UV glue for plexiglas

- Crystal transparency
- Invisible seam
- Monolithic connection
- Обезжиривание не требуется
- Without preliminary grinding
- Suitable for gluing large surfaces
- Leaves no sticky layer or white marks
Объем 120мл
Цена 2240 рублей
Low viscosity UV adhesive for plexiglass based on acrylic monomers. In the process of gluing, the surfaces and composition to be glued are diffused, and then, under the influence of UV radiation, complete polymerization. The result is an almost monolithic compound with a close chemical composition, physical, mechanical characteristics and, what is important, with almost identical optical properties to plexiglass. A polished seam can only be distinguished by careful examination of the object.
Акриловый УФ клей позволяет склеивать поверхности после лазерной резки без дополнительной шлифовки. Обезжиривание не требуется. После полимеризации не остается липкого слоя и нет необходимости в постотверджении.
Suitable for both end bonding and surface bonding.

Mode of application
- Prepare plexiglass: warm it up to 75 degrees for 1 hour. Allow to cool very slowly.
- Apply glue to the contact point with the expectation of spreading. Do not shake before use. Remove small air bubbles with a thin stick or a small amount of acetone using a spray.
- Attach the piece to be glued and, while holding it, turn on the UV source for 30-90 seconds. After setting, release the part and continue irradiation under ultraviolet light for up to 1 hour. For best results, leave in natural light for several hours for maximum cure.
- Polish the surface if necessary.
Specifications
Rated viscosity - 600cps
Density, g / cm3 - 1
Refractive index of the polymer - 1.5
Drying time at 23 degrees, min - 5
Shelf life, months - 3
Curing
Мощность уф (фактическая), Вт — от 18
Range, nm - 360-400
Расстояние от источника, см — 10-30
Время схватывания, сек — 30-90
Время отверждения, мин — до 15
Layer thickness, mm - 0.05-0.9